You Bought The Wrong Project Car, Now What?

Last week a friend dropped by the shop. He wanted me to take a look at a potential project car. It was a complete, albeit somewhat rusty, ’54 Willys Wagon. The truck was a cool one, but it needed wiring, floorpans, glass and the engine condition was unknown. A viable and worthy project to the right owner. On the ride home, I tried to paint a realistic picture of the work it would take to resurrecting the nifty old 4×4 without swaying his decision one way or the other.

This experience got me thinking about my project car. I’m going on seven years now in this build. I chose my Ford because it was close enough to drive home, and it ran well enough to get there. My logic was that I would save money because I wouldn’t need a tow. In hindsight, I should have kept shopping for a less rusty, more complete car that maybe needed a ride to my house.

I bought it hoping to try my hand at upholstery.  At the time, I looked at the empty shell and saw a blank slate. However, once I got it home I realized the car needed everything. It needed wiring, a fuel system (to replace the antifreeze jug full of gas bungee corded to the inner fender next to the engine), brakes, steering, glass, every system needed attention. And then there was the rust. Before I could start in learning about upholstery I had floors and body mounts to cut out and fresh ones to weld it. Thus began the saga of my ’49 Ford.

Basically, I bought the wrong car. Between bouts of welding and wrench twiddling, I’ve had lots of time to ruminate over what I would have done differently. The way I see it there are three paths for those folks who have hauled home a project only to find they’re in over their head. Bail out, sink or learn to swim.

Picture

 

Bail Out 

Capture

If you bought the wrong car and you’re over your head craigslist can be a lifeline. Say you got your precious four-wheeled treasure home only to find out the floorpans are completely rusted out. Or maybe the differential explodes a mere block from your house on its voyage home from the seller. Rather than letting that heap molder in your driveway for the next decade, it’s not going to get better on its own, take the hit now and just post it on craigslist. Even if you have to sell it at a bit of a loss, you’ll know better next time. There’s no shame in passing on a project you can’t hack, and the little blow to your wallet/pride is better than the next option.

Sink

 

468843_orig

This is probably the saddest route. We’ve all seen an old car or motorcycle that’s slowly returning to Earth in someone’s driveway or backyard. Maybe it’s a second gen Camaro or a perfectly patinaed Corvair that’s sitting on four flats with the headliner falling in. They’re usually partially disassembled and left to rot after the owner’s initial enthusiasm has waned. And due to some delusion, the owner won’t sell. Instead, they say, “I’ll fix it someday.” Don’t be this project owner. If you’re in over your head don’t let pride, shame, nostalgia any other silly feeling attach to that old iron. Sell it and move on with your life.

Learn to Swim

Picture

Get the tools and get to work. This is the hardest method. Most people work for a living. The idea of putting in more work at the end of the day rather than sitting in front of the TV or computer is almost unfathomable. The truth is, if you don’t do it you’ll have to pay someone to do it. Either way, you’re going to work for it. Learning to weld, spread body filler, or rebuild a carburetor isn’t something that comes naturally to most folks. But with practice and YouTube research, these are skills anyone can pick up.

Lessons Learned

By starting at almost zero, I have learned a lot about what it takes to put a car back together. And it provided source material for a blog dedicated to the Ford. But it has cost me more time and money than it probably should have. I negotiated the car down $2,000 from the initial asking price and still probably paid too much for what I drove home. If I knew what to look for I would have saved myself a lot of time, money and heartache.

By the looks of it, my ’49 was put out to pasture a long time ago. How it ended up back in a suburban garage, I don’t know. The frame was (is if I’m honest) full of silt. The suspension was encrusted with a mixture of red clay and leaked oil/grease. The differential is caked with a half inch of diff fluid and some sort of livestock fur. The original floors were perforated with rust holes. Over these holes were riveted sheet metal plates to prevent your feet from touching the asphalt. This is what I call a farmer fix. It’s ok for the short term, but it doesn’t solve any rust issues. It’s like trying to cure cancer with Benedryl.

So why do I keep hammering at my project? In short, I’m a stubborn and curious man. The money is already spent, and I’ve got buckets of sweat equity in this thing. That said, for the right price, I’d happily pass it on to the next owner. I’d also feel good that they could enjoy the solid work I’ve done to make it a better car.

Capture

Final Thoughts

  • Rust – if you see it, there’s probably more. It costs either a lot of time or a lot of money to fix. Do you want to invest in tools? Do you want to learn to cut it out and weld it new stuff?
  • Buy something as close to what you want as possible. This lets you spend your time and money making the car reflect your taste rather than merely making it a viable car. A little more money up front can save you time once your project is home. That white car without issues is a better option than the busted up red car, even though you like red better. Paint is only skin deep.
  • Four eyes are better than two. Get a bud to go with you, chances are they’ll see something you miss.
  • Don’t get project goggles. It’s so easy to get infatuated with a car or bike and completely overlook some red flags.
  • Be honest with yourself. Assess the skills and tools you have and your budget for your project.
  • Once it’s home, do the hard stuff first. Your enthusiasm is probably never going to be higher than right after you get it home.
  • Don’t fall into the scarcity mindset. “Oh man, if I don’t get this one, I’ll never get another chance.” I don’t know how many times I’ve bought something for what I thought was a good deal only to see another, better option the next week.
  • Know your expectations. If you want a spotless show car, understand that it entails a ton more work than the patinaed driver will.

6 thoughts on “You Bought The Wrong Project Car, Now What?

  1. Aaron, this is by far your best piece. Keep it up. Great reading, as I wait for the local shop to tell me the final bill for my car’s new rear brakes, right front axle, and everything else I lack the skill and tools to repair.

    Like

  2. Great Read… I’m glad I sold my last Z and knew where I was with it and didn’t go the “Sink” route.
    This really made me want to get another Z, a dedicated garage space, and get to wrenchin.
    Nice article Aaron!

    Like

  3. Such truth here. It can be hard to admit how much pride is a factor in these projects, especially when the project is fetishised from the minute you see the CL ad. What do you think about the life lines in these situations? Fellow kooks, either on the web or around the block, that give a ray of hope with their experience on that differential with your exact year of late model ford.

    Like

    1. Agreed. Tapping out of a project that’s not right for you is healthy. Great point about the kooks. I think I should have mentioned outside support. One of the best aspects of the internet is how many people share information. Thanks for reading me.

      Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s